博客
轉載：How to use .cir model in Capture
||
經常碰到orcad仿真庫中找不到某些器件的情況，但是從這些器件的廠家網站上往往可以下到其spice model，一般是.cir文件，下面介紹一下如何使用這些.cir文件。以AD8131.cir為例。
首先，運行Model Editor (in PSpice Accessories)，打開ADAD8131.cir文件，另存為（save as）AD8131.lib，add this to pspice library,for simulation purpose.
use File->Export to capture part library… ,to generate AD8131.olb，add this to capture library，this can perform circuit connection.
when you run simulation ,open simulation setting/configuration file/library add the AD8131.lib to this design.
首先，運行Model Editor (in PSpice Accessories)，打開ADAD8131.cir文件，另存為（save as）AD8131.lib，add this to pspice library,for simulation purpose.
use File->Export to capture part library… ,to generate AD8131.olb，add this to capture library，this can perform circuit connection.
when you run simulation ,open simulation setting/configuration file/library add the AD8131.lib to this design.
