|
Intersil公司的ISL9305H是密你電源管理IC(mini-PMIC), 集成了兩個(gè)高效的3MHz同步降壓轉換器(DCD1和DCD2)以及兩個(gè)低輸入低壓降的線(xiàn)路穩壓器(LDO1和LDO2), DCD1和DCD2可提供1.5A電流, LDO1和LDO2可提供300A電流,主要用于手機和智能手機,PDA,PMP和手持儀表,DSP內核電源以及用單節鋰電池電源的設備.本文介紹了ISL9305H主要特性,方框圖, 典型應用電路圖以及ISL9305IRTZEVAL1Z評估板電路圖,材料清單與PCB布局圖. ISL9305H is an integrated mini Power Management IC (mini-PMIC) for powering low-voltage microprocessor, or applications using a single Li-Ion or Li-Polymer cell battery to power multiple voltage rails. ISL9305H integrates two high-efficiency 3MHz synchronous step-down converters (DCD1 and DCD2) and two low-input, low-dropout linear regulators (LDO1 and LDO2). The 3MHz PWM switching frequency allows the use of very small external inductors and apacitors. Both step-down converters can enter skip mode under light load conditions to further improve the efficiency and maximize the battery life. For noise sensitive applications, they can also be programmed through I2C interface to operate in forced PWM mode regardless of the load current condition. The I2C interface supports on-the-fly slew rate control of the output voltage from 0.825V to 3.6V at 25mV/step size for dynamic power saving. Each step-down converter can supply up to 1.5A load current. The default output voltage can be set from 0.8V to VIN using external feedback resistors on the adjustable version, or the ISL9305H can be ordered in factory pre-set power-up default voltages in increments of 100mV from 0.9V to 3.6V. ISL9305H also provides two 300mA low dropout (LDO) regulators. The input voltage range is 1.5V to 5.5V allowing them to be powered from one of the on-chip step-down converters or directly from the battery. The default LDO output comes with factory pre-set fixed output voltage options between 0.9V to 3.3V. ISL9305H is available in a 4mmx4mm 16 Ld TQFN package. ISL9305H主要特性: • Dual 1.5A, Synchronous Step-down Converters and Dual 300mA, General-purpose LDOs • Input Voltage Range - DCD1/DCD2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5V to 5.5V - LDO1/LDO2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5V to 5.5V • 400kb/s I2C-Bus Series Interface Transfers the Control Data Between the Host Controller and the ISL9305H • Adjustable Output Voltage - DCD1/DCD2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.8V to VIN - Fixed Output I2C Programmability • At 25mV/Step . . . . . . . . . . . . . . . . . . . . . . . . . .0.825V to 3.6V • LDO1/LDO2 Output Voltage I2C Programmability - At 50mV/Step . . . . . . . . . . . . . . . . . . . . . . . . . . 0.9V to 3.3V • 50μA IQ (Typ) with DCD1/DCD2 in Skip Mode; 20μA IQ (Typ) for Each Enabled LDO • On-the-fly I2C Programming of DC/DC and LDO Output Voltages • DCD1/DCD2 I2C Programmable Skip Mode Under Light Load or Forced Fixed Switching Frequency PWM Mode • Small, Thin 4mmx4mm TQFN Package ISL9305H應用: • Cellular Phones, Smart Phones • PDAs, Portable Media Players, Portable Instruments • Single Li-Ion/Li-Polymer Battery-Powered Equipment • DSP Core Power 
圖1.ISL9305H方框圖
圖2.ISL9305H典型應用電路圖 ISL9305IRTZEVAL1Z 和ISL9305HIRTZEVAL1Z評估板 • Input voltage rating from 2.3V to 5.5V • Two 800mA buck converters for ISL9305 and two 1.5A buck converters for ISL9305H • Two 300mA LDOs • Output voltages are programmable with I2C • 3MHz switching frequency • Connector, test point and Jumper
圖3.ISL9305HIRTZEVAL1Z評估板電路圖 ISL9305HIRTZEVAL1Z評估板材料清單:
圖4.ISL9305HIRTZEVAL1Z評估板PCB布局圖 詳情請見(jiàn): http://www.intersil.com/data/fn/fn7724.pdf 和 http://www.intersil.com/data/an/an1564.pdf |
